#Ghost Squid Controller

This is the firmware for Rev. 20140518 of the Ghost Squid controller by Bathroom Epiphanies, a replacement controller for the Cooler Master Quick Fire XT.

The code was adapted from the BathroomEpiphanies QMK Firmware.

• Keyboard Maintainer: QMK Community
• Hardware Supported: Ghost Squid
• Hardware Availability: 1upkeyboards

Enter the bootloader in 3 ways:

• Bootmagic reset: Hold down the key at (0,0) in the matrix (usually the top left key or Escape) and plug in the keyboard
• Physical reset button: Briefly press the button on the back of the PCB - some may have pads you must short instead
• Keycode in layout: Press the key mapped to QK_BOOT if it is available

Make example for this keyboard (after setting up your build environment):

104 key default layout:

make bpiphany/ghost_squid:default

Flashing example for this keyboard:

make bpiphany/ghost_squid:default:flash

See the build environment setup and the make instructions for more information. Brand new to QMK? Start with our Complete Newbs Guide.