#Sleepy Keeb

The Sleepy Keeb is a hand-wired keyboard based on the 4x12 Planck layout. The Sleepy Keeb integrates hot-swap socket and diode holders into the plate for easier building.

• Keyboard Maintainer: Sleepy Craft Studios
• Hardware Supported: Pro Micro development board (and clones/adapations of)
• Hardware Availability: Sleepy Craft Studios Shop for kits and full builds, Sleepy Craft Studios Downloads for CC-BY-SA-NC licensed stl files for 3D printing.

Make example for this keyboard (after setting up your build environment):

make sleepy_keeb:default

Flashing example for this keyboard:

make sleepy_keeb:default:flash

See the build environment setup and the make instructions for more information. Brand new to QMK? Start with our Complete Newbs Guide.

#Bootloader

Enter the bootloader in 3 ways:

• Bootmagic reset: Hold down the key at (0,0) in the matrix (usually the top left key or Escape) and plug in the keyboard
• Physical reset button: Briefly press the button on the back of the PCB - some may have pads you must short instead
• Keycode in layout: Press the key mapped to QK_BOOT if it is available