#Dactyl ManuForm

Pair of Dactyl Manuform 4x6

Forked from the Dactyl, the Dactyl ManuForm is a parameterized, handwired, split bodied, tented, concave key-well design that incorporates the thumb cluster from the ManuForm.

• Keyboard Maintainer: Tom Short
• Hardware Supported: Pro Micro, or clone of
• Hardware Availability: Github

#Variants

Dactyl ManuForm's are built in variations that cater for different row and column counts, and thumb clusters.

As standard:

• The finger keywell bottom row has 2 keys, 1 each in ring and middle columns
  • Exception to this rule is the 5x7 variant - that has two additional keys, per half, in this row
• The thumb cluster has 6 keys, arranged in a staggered 2 columns by 3 rows

Variants are denoted as RowCountxColumnCount(_Alteration)

#Row

#Column

#Alteration

#Case Files Generator

Dactyl Generator, created by rianadon, is a web based file generator that negates having to compose case files using programming languages, which was the matter when using the original Dactyl and Dactyl ManuForm GitHub repos, by instead compiling case files based on options and parameters configured in a web front end.

#Compile

Make example for this keyboard (after setting up your build environment) in the 5x6 variant:

make handwired/dactyl_manuform/5x6:default

Flashing example for this keyboard:

make handwired/dactyl_manuform/5x6:default:flash

See the build environment setup and the make instructions for more information. Brand new to QMK? Start with our Complete Newbs Guide.

#Keymaps

#Default

The default functional layout, based on QWERTY, and every variant has this keymap; used as a starting point/template for custom keymaps and for debugging purposes when soldering key matrix to controller.

#VIA

Similar to Default but adds support for the VIA keymap configurator. Layer count set to 4 to comply with VIA defaults, and remaps keys to accommodate this constraint, if applicable.

Variants with VIA support:

• 4x6
• 5x6_5
• 5x7

#Miryoku

For more information on this layout schematic, please see the Miryoku Reference Manual.
For QMK specifics, please see Miryoku QMK.

Variants with Miryoku support:

• 4x5
• 4x5_5
• 4x6
• 4x6_5
• 5x6

#Non-Pro Micro Controller Compilation

If building a Dactyl Manuform with controllers that aren't a pro micro, the Converter feature of QMK will allow compilation of firmware for the intended variant and supported controller without having to create a new QMK keyboard/keymap.
Please see Converters documentation for list of controllers that are supported converting from pro_micro and how to implement conversion.

#Flashing

To flash your board with generated firmware file, please see Flashing Instructions and Bootloader Information

#Handedness configurations

See Handedness documentation for more information on configuring handedness/master half.

#VIA Configuration

Variants with a via keymap are VIA capable. Compile firmware, for enabled variant, with it's via keymap and flash board with this firmware file.

qmk compile -kb handwired/dactyl_manuform/4x6 -km via

#Bootloader

Enter the bootloader in 3 ways:

• Bootmagic reset: If enabled, hold down the key at (0,0) in the matrix (usually the top left key or Escape) and plug in the keyboard
• Physical reset button: Briefly press the button on the back of the PCB or controller - some may have pads you must short instead
• Keycode in layout: Press the key mapped to QK_BOOT if it is available